ON30 or S Scale - A Frame King Post Bridge, fully assembled as shown. for Sale

On eBay Now...

ON30 or S Scale - A Frame King Post Bridge, fully assembled as shown. For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

ON30 or S Scale - A Frame King Post Bridge, fully assembled as shown.:
$37.00

Fully Assembled ON30 Scale A Frame Truss Bridge

Made of Poplar Wood in our shop.

Stained with our own custom Water based weathering stain which will not rub off.

Track bed runners are just under 1-1/2" wide by 7-1/2" long

The inside clearance width between the A frames is 3-1/8" inside measurement

The bridge width measurement at its widest point is 5-1/2"

The height of the bridge from its lowest point to its highest point is 4-1/8"

These photos are of the bridge pictured and is the one for sale here and is the bridge you will receive.

This bridge is made exclusively with 3/16" Square lumber and steel stress rods..

This is a true on30 scale bridge.

We realize that ON30 is O gage and have had many people point out that O gage is 1/4" scale and therefore O gage bridges should be build out of 1/4" wood stock. However in reality ON30 is narrow gage and the fact is that Narrow Gage railroads were not built out of the same timbers that full sizze railroads were... It would be nonsensical to build a narrow gage railroad bridge out of the same timbers that they used on the Union Pacific. Therefore we use 3/16" stock on our ON30 Bridges as it is much closer to true Narrow Gage Scale. An ON30 scale engine running across an O Scale bridge is unrealistic and it looks it..

We have been building railroad bridges for over 20 years.