37mm Projectile Payload Shells - 10 Pack - The LongRanger - for Sale

On eBay Now...

37mm Projectile Payload Shells - 10 Pack - The LongRanger - For Sale

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

37mm Projectile Payload Shells - 10 Pack - The LongRanger - :
$70.00

Intended as an inert display piece only! Perfect fit for 37mm barrel only for practice and display.

The same sweet sweet goodness of the Longranger but in a more economical 10 pack WITH free shipping!!!

Save some money and buy the big pack!

Please contact me directly for bulk orders and better pricing

This 10pack of LongRangers is the best and most accurate 3d printed projectile for your 37mm needs. The LongRanger has the largest fin surface area and largest capacity of any projectile on the market which results in improved accuracy and more fun at the range!

Heres some important information about this listing. Lets get this out of the way then on to the fun stuff!

**The LongRanger will need to be seated in shells 3 inches or longer due to the length**

**This is a 3d printed item, and as such may have minor cosmetic imperfections; these will in no way impact the performance of the projectile**

**Due to the variance in different manufacturers and aftermarket shells please test that the shell slides through the barrel easily, and that the shell seats firmly in the shell casing. This is basic safety. If the fit is too tight, simply remove material with light sanding until desired fit is achieved**

**Although these projectiles snap together it is recommended to use glue (superglue works well) to adhere the 2 halves together to ensure they don\'t come apart during launch**

**Projectiles and red press cups only, no hulls or fuse are included**

Now for the good stuff!

-Unique 2-piece snap together design allows the user to fill these projectiles with a multitude of substances.

-A large fin section allows this projectile to stabilize in flight with much better accuracy than other projectiles!

-The lower finned portion has a fuse hole that fits standard fuse (can also be plugged with hot glue if not used)

-Recessed design allows the projectile to fit snug in your casing - no need for ineffective gimmicks like rubber bands or tape for a sealant

-Includes a red press cup for each projectile that firmly holds your lift in the bushing.

CAD designed and 3D printed in PLA

Check federal, state and local laws and regulations before constructing any 37mm loads. Like most things fun, the 37mm hobby has inherent risks. Buyer assumes all risks involved in loading, reloading, constructing and using 37mm cartridges.

These are not weapons and should never be used as such. Not to be used on any living target.

If you have any questions please reach out, I am more than happy to answer whatever I can.

Thanks!

-Newton Ballistics